Articles Blog

Superduo Armband * DIY * Twin Bead Bracelet [eng sub]

Superduo Armband * DIY * Twin Bead Bracelet [eng sub]


We are going to need superduo beads, very small beads, a closure, a nylon thread (size 0,25mm) and a needle. We are going to pick up two superduo beads. Make sure to leave a tale, because we are going to need the thread in the end. Now, we run the needle up through the top hole of bead. That is the bead, where your thread is coming out. Then we pick up two more beads. Now we run the needle up through the top hole of the other bead and we can see the herringbone pattern. Then we pick up a small bead and pull the needle through the next hole. Make sure to pull it tight. Then we pick up two superduo beads. You can see that the thread is coming out of the top bead and we are going to pull the needle through the other bead. Then we pick up a small bead and pull the needle through the next hole. We pick up two superduo beads. Now you can see that the thread is coming out of the lower bead and we are going to pull the needle through the other bead. Then again a small bead. And we pull the needle through the next hole. We are going to proceed like this until we have the appropriate length for our wrist. When the bracelet is long enough, we are going to pick up a single superduo bead. and we run the needle up through the top hole of the top bead. Pull it tight. Now, we pull the needle through the outer hole of the bead, that we just added. Now, we can attach it to our closure. We pull the needle through the eyelet of the closure and through the bead a couple of times. Then we are going to sew the thread, by pulling it through a couple of beads. Now, we are going to make a knot by pulling the thread through a loop. I´m going to repeat this. At the end we are going to make a double knot and cut off the thread. Now we are going to pick up a small bead at the other side. And we pull the thread through both holes of the two superduo beads. Then we pull the needle through the small bead. And then we are going to attach the closure to this side of the bracelet. We repeat the same we did on the other side. After making a double knot, you can cut off the thread and the bracelet is finished.

12 thoughts on “Superduo Armband * DIY * Twin Bead Bracelet [eng sub]”

  1. Wieder ein tolles Armband, die Idee mit den Perlen mit 2 Löchern muss man auch erst mal kommen… mir gefällt aber auch das Lederarmband, das du am gleichen Arm trägst – auch selbst gemacht?

  2. Diese Doppellochperlen kannte ich bis jetzt noch gar nicht. Ergeben aber wirklich ein sehr schönes Bild. Gefällt mir richtig gut. Wo hast du denn den tollen Verschluß her, wenn ich fragen darf? 🙂 Ich mach auch Makramee-Armbänder und immer einen Knopf nehmen oder einen Schiebeverschluß machen, passt nicht immer und die Magnetverschlüsse halten nicht wirklich viel aus, deinen finde ich, was ich so erkennen kann, mit am Schönsten und er scheint auch gut das Armband geschlossen zu halten.
    LG 🙂

  3. Love this bracelet very sweet and your instructions are easy to follow thank you so much, I'm really happy how mine has turned out.

  4. Thanks a Ton!.Its so Cute & Grand ! I have bought Superduo Beads from Amazon. Will Black & White Superduo bracelet look Good? Keep Posting ! Bye!.

Leave a Reply

Your email address will not be published. Required fields are marked *