Articles

Armband selber machen * DIY * Bracelet [eng sub]


We are going to need leather band, a nylon thread, a ball chain, end caps, jump rings, a closure and pliers. We cut off a length that reaches two times around our wrist. And we need two of them. Next, we lay the ends of our leather band into the end cap and close it. We repeat this with the other end. Now, we take our nylon thread and wrap it around the leather bands a couple of times. Then we tie knots. If you want you can add a drop of adhesive to the knot, to make sure it stays closed. We cut off the end of the thread. Then we take our ball chain. And we lay the chain on the leather bands. Then we wrap the nylon thread around the leather bands and between each of these balls. At the end, we cut off the ball chain and wrap the nylon thread around the leather bands a couple of times and tie a knot. Next, we take our jump rings and run them through the end caps. And we add the closure to one jump ring. Then we close the jump rings. Now, we are finished. If you want you can make the bracelet smaller – so it only fits one time around your wrist.

Leave a Reply

Your email address will not be published. Required fields are marked *